|
|
|
|
|
For Palm iiic |
| |
|
|
|
 |
Step: 1
Using the including screwdriver remove the four screws from the Case. |
 |
Step: 2
Using your finger, pry open the case starting with one of the top corners of the PDA. The back of the case should easily unsnap from the rest of the PDA. |
 |
Step: 3
Once the case is separated, you will notice the battery at bottom of the PDA is attached to the motherboard by a black and red power cable. |
 |
Step: 4
Disconnect the battery connector by gently pulling the black and red power cable towards the nearest adge of the PDA. |
 |
Step: 5
Using your finger or the top of a screwdriver, carefully lift the battery from its plastic guides. The battery should pop out and you can now remove it from the PDA.
Please pay attention the original orientation (power cable towards the top of the PDA). Connect the power cable of the new battery by positioning it within the socket on the motherboard, pushing it in.
Snap one the cover and put back the four screws.
Your new battery will need a minimum of three hours of charging before first use. |
|
|
|
|