|
|
|
|
|
For Apple iPOD 4th Generation |
| |
|
|
|
 |
Step: 1
Using the included screwdriver begin to pry open the side of the case, starting around the area that lines up with fwd bottom as shown. Gently twist the screw driver and pry up the bottom corner closest to the screwdriver. |
 |
Step: 2
With the screwdriver wedged inside the case, carefully work your way-up the top of the case, unclipping the case clips as you go. |
 |
Step: 3
With one side of the case fully unclipped, using your fingers to support the hard drive you can flip the main section of the IPOD face down. Be carefully not to damage the ribbon cable connected to the back case cover. |
 |
 |
Step: 4
Using the screwdriver and your finger, disconnect the power cord connector from the socket. Please pay attention to the original orientation.
Using the included tools wrench, remove the two screw at the end of the main board, next to the power cable. |
 |
 |
Step: 5
Slide the power cable around the main board. |
 |
Step: 6
Holding the hard drive with your hand and using your finger or the the tip of a screwdriver, carefully unglue and remove the battery from the glue spots. Be careful not to over extend and damage the hand drive ribbon cables.
Apply the new battery to the original orientation and glue spots, move the power cable around the main board to the original spot and insert, put back the two screws, wile supporting the hand drive with your finger flip the main section back over to the front and snap the case back on.
Your new battery will need a minimum of three hours of charging before first use. |
|
|
|
|