|
|
|
|
|
For Palm Zire 71 |
| |
|
|
|
 |
Step: 1
Pulling down on the back case cover of the PDA to reveal the digital camera and some screw. Use the included T-5 tools wrench to remove the two screws. |
 |
Step: 2
After the screw are removed, flip the device face up and begin prying the case apart starting from the top and working your way down the adge of the PDA. |
 |
Step: 3
Once the case unsnaps, the back cover should still be attached by a ribbon cable. Move the back case cover to the side to allow access to the battery. The battery should be face down in a sliver battery case and should still be attached to the PDA by its power cable. Flip the battery and case towards the top of the PDA to get a better view of the battery. |
 |
Step: 4
To remove the battery and case, disconnect the power cable by gently pulling upward on the connector with your finger. The while connector should unsnap from the motherboard and allow you to remove the battery. |
 |
Step: 5
The original battery should be attached to the battery case by a very small amount of glue. Gently pull on the battery to remove it from its case.
Please pay attention to have the original orientation (power cable towards the top of the PDA). Apply the new battery within the battery case, reattach the power cable and reapply the battery/battery case to the back of the motherboard. Connect the power cable of the new battery by positioning it over the socket, pushing it in.
Snap the cover back together and put back two screws.
Your new battery will need a minimum of three hours of charging before first use. |
|
|
|
|