|
|
|
|
|
For Palm Treo 90 |
| |
|
|
|
 |
Step: 1
Before attempting battery installation, make remove your memory card from the memory card slot. |
 |
Step: 2
Using the included T-5 wrench, remove the four screw from the case. Using your fingers, pry open the case starting with one of the bottom corners of the PDA. The back of the case should easily unsnap from rest of the PDA. |
 |
Step: 3
Once the case is separated, you will have easy access to have the battery and the power cable. The battery is secured by a small amount of glue. Gently pulling on the battery should free it from the PDA. |
 |
Step: 4
Disconnect the battery connector by gently pulling on the back and red power cable.
please pay attention to have the original orientation (power cable towards the power connector). Connect the power cable of the new battery by positioning it within the socket on the motherboard, pushing it in. Apply the new battery within the guide brackets... it should stick to the original glue spots.
Snap on the cover and put back the single screw.
Your new battery will need a minimum of three hours of charging before first use. |
|
|
|
|