|
|
|
|
|
For Palm Treo 270 / 300 |
| |
|
|
|
 |
Step: 1
Using the included screwdriver, remove the four screw from the case. Using your fingers, pry open the case starting with one of the bottom corners of the corners of the PDA. The back of the case should easily unsnap from the rest of the PDA. |
 |
Step: 2
Using your fingers, pry open the case starting with one of the bottom corners of the corners of the PDA. The back of the case should easily unsnap from the rest of the PDA. But will still be attached by the battery power cord. |
 |
Step: 3
Once the case is separated, you will have easy access to the battery and the power cable. The battery is secured by a small amount of glue. Gently pulling on the battery should free it from the PDA. |
 |
Step: 4
Disconnect the battery connector by gently pulling on the back and red power cable.
Please pay attention to have the original orientation (power cable towards the power connector). power cable of the new battery by positioning it within the socket on the motherboard, pushing it in, Apply the new battery within the guide brackets...it should stick to the original glue spots.
Snap on the cover and put back the single screw.
Your new battery will need a minimum of three hours of charging before first use. |
|
|
|
|