|
|
|
|
|
For Sony PEG-S360 |
| |
|
|
|
 |
Step: 1
Using the included screwdriver, remove the five screws from the outside case cover. |
 |
Step: 2
Once the screw are removed, carefully pry off the front case cover surrounding the screw and bottoms. |
 |
Step: 3
Using the included screwdriver, remove the two screw that attach the motherboard to the back of the case. |
 |
Step: 4
After the two screws are removed, flip over the LCD screen. The screen should still be attached by ribbon and power cable. This process will give you access to the third motherboard screw. Remove this screw. |
 |
Step: 5
Disconnect the battery power cable connector by gently pulling on the ribbon cable. This connector is located near the bottom of the PDA. |
 |
Step: 6
To remove the battery carefully lift the motherboard section covering the battery. Once you have enough room to remove the battery, carefully pull it out. To insert the new battery, apply the new battery on the case within the guide brackets. The battery should stick to original glue spots. Line-up the power cable connector with the power socket. Use your finger or the tip of a screwdriver to push the connector into the socket. Please pay attention to have the original orientation.
Put back the three motherboard screw. Snap on the front case cover and put back the five screw.
Your new battery will need a minimum of three hours of charging before first use. |
|
|
|
|