|
|
|
|
|
For Palm M130 |
| |
|
|
|
|
Step: 1
Using the including screwdriver remove the four screws from the Case. |
|
Step: 2
Using the tip of the screwdriver, pry open the case starting with one of the top corners of the PDA. The back of the case should easily unsnap from the rest of the PDA. |
|
Step: 3
Once the case is separated, flip over the front cover to expose the battery compartment. You will notice the battery at the bottom of the PDA is attached to the motherboard by a black and red power cable. |
|
Step: 4
Using your finger, loosen the battery from its compartment. carefully lift the battery...its should be held in place by small amount of the glue. The battery should still be attached by its power cable. |
|
Step: 5
With the battery loose from the back of the case, flip over the motherboard section of the PDA to expose the battery connector. Gently pull on the power cable to disconnect the battery. The battery can now removed from the PDA. |
|
Step: 6
Please pay attention to have original orientation (power cable towards the connector of the PDA). Connect the power cable of the new battery by positioning it within the socket on the motherboard, pushing it in. Reapply the battery within its original glue spots. Snap on the cover and put back the four screws. Your new battery will need a minimum of three hours of charging before first use. |
|
|
