|
|
|
|
|
For HP 3900 |
| |
|
|
|
|
Step: 1
Using the included wrench remove the four screws from case. |
|
Step: 2
Using the included flat head screwdriver pry open the IPAQ case starting at the bottom. |
|
Step: 3
Continue prying the case towards the corners until the full length of the case pops open. |
|
Step: 4
Lift open the IPAQ case. You should notice a yellow power cable that runs from the motherboard to the battery. The battery is glued to the case. |
|
Step: 5
Using the flat head screwdriver, carefully lift the yellow cable power cable plug connector away from the battery connector. The case and battery should now be free from the rest of the IPAQ. |
|
Step: 6
Using the flat head screwdriver unglue the old battery from the case cover (DON'T PUNCTURE THE BATTERY). Apply the new battery on the case within the guide brackets. The battery should stick to the original glue spots. Please pay attention to have the original orientation (Connector towards the bottom of the IPAQ). Connect the ribbon cable by positioning it over socket on the motherboard, pushing it in. Snap on the cover and put back the single screw. Your new battery will need a minimum of three hours of charging before first use. |
|
|
