|
|
|
|
|
For Sony Clie UX40 / UX50 |
| |
|
|
|
 |
Step: 1
Using the included screwdriver, remove the four screws from the battery case. |
 |
Step: 2
Once the screw are removed, pull the bottom cover away from the Clie. The cover should still be attached by a sound cable, so slide the cover towards the front of the PDA to allow access to the battery. Pull the battery away from the case to allow access to the battery power connector. |
 |
Step: 3
To remove the battery power cable, care fully pull the battery away from the connector. To insert the new battery, line-up the power cable connector with the power socket. Use your finger or the tip of a screwdriver to push the connector into the socket. Apply the new battery on the case within the guide brackets. Please pay attention to have the original orientation (power cable on the same aide as power connector).
Snap on the back cover of the Clie and put back the four screws.
Your new battery will need a minimum of three hours of charging before first use. |
|
|
|
|